Cisco SX10 User Manual

14
D1509707 User Guide
Cisco TelePresence TRC 6
Produced: April 2016 for CE 8.1
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
Change the Layout of the Screen
Whenever you share content or you
are in video conference, you will
be able to change the layout of the
video shown on the screen.
Your system cannot initiate video
conferences unless certain
infrastructure exists in your
organization. If in doubt, consult your
video support team.
You can, however, be invited to a
video conference by others. The
ability to change the screen layout
will then apply.
Any changes you make here will not
aect others than you.
About Layout
Screen layout
Navigate to Layout ( ) in the upper right corner and
press OK on the remote control. This icon will appear
only when relevant.
Use the horizontal Arrow keys on the remote control to
move horizontally to the new layout you would like to use
and press OK.

Cisco SX10 Specifications

General

Maximum Resolution	1920 x 1080
Video Outputs	1 x HDMI
Video Standards	H.264
Audio Standards	AAC-LD
Network Interface	10/100/1000 Ethernet
Frame Rate	60 fps
Network Protocols	HTTP, HTTPS, SSH, Telnet
Audio Outputs	1x 3.5mm stereo
Operating Temperature	0°C
Storage Temperature	-20°C to 60°C
Relative Humidity	10% to 90%