Cisco SX10 User Manual

22
D1509707 User Guide
Cisco TelePresence TRC 6
Produced: April 2016 for CE 8.1
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
Start and Stop Presentation
Share Content
Make sure your presentation source is connected and
On. You may need to select Share (located in the center
bottom of the screen, if it appears) and press OK on the
remote control.
Your source will now be shared.
The size of the shared image is controlled by means of
the Minimize/Maximize eld which appears along the
bottom of the display (number 2 from the left). Select
this and press OK on the remote control, if needed.
To stop sharing content, select Stop sharing (which
appears along the bottom of the display (number 1 from
the left) and press OK on the remote control.
Use this feature to share content
on your PC in a call or outside a
call. The procedure is the same, but
shown here is the in-call way only.
About Content Sharing

Cisco SX10 Specifications

General

Maximum Resolution	1920 x 1080
Video Outputs	1 x HDMI
Video Standards	H.264
Audio Standards	AAC-LD
Network Interface	10/100/1000 Ethernet
Frame Rate	60 fps
Network Protocols	HTTP, HTTPS, SSH, Telnet
Audio Outputs	1x 3.5mm stereo
Operating Temperature	0°C
Storage Temperature	-20°C to 60°C
Relative Humidity	10% to 90%