LAB 7B: Wireless
Cisco Unified Communications Technical Training
Page 115 of 171
Unpack and verify your power supply for the SPA525 phones.
4) Follow the on screen instructions provided by the wireless setup wizard.
a. Note: The SPA525G phone does not ship with a power supply. In order for the phone to
operate in Wireless-G mode, a PA100 power supply is required and must be ordered
separately.
5) Unpack and assemble the Cisco SPA525G IP phones as described in the documentation provided
with the phones.
6) For each phone, plug the power supply cable into the phone base and connect the PA100 power
supply to a power source.
7) Select next to continue.
To Next Page
Loading...
General