APPENDIX C: PPPoE on the WAN
APPENDIX C: PPPoE on the WAN
Introduction:
PPPoE on the WAN interface of UC500 is also a connection option. One example of this WAN
deployment would be to connect the WAN interface though Ethernet to a DSL modem to a Service
Provider. In this case the PPPoE would be running on the UC500 instead of the DSL modem
Objective:
Configure PPPoE on the WAN interface using CCA. Understand the pre-requisite steps needed to
enable PPPoE on the WAN interface
Lab Set-up:
Refer to the main diagram
Setup Steps:
1. Click on “Configure -> Internet Connection”
2. Select “WAN Interface FastEthernet 0/0”
To Next Page
Loading...
General