LAB 7A: Security on UC500 and SR520
LAB 7A: Security on UC500 and SR520
Introduction:
The Cisco SR520 provides Asymmetric Digital Subscriber Line (ADSL) or FastEthernet WAN
termination and advanced security features for a Cisco Smart Business Communications System (SBCS)
network. This document describes how to connect a Cisco UC500 behind a Cisco SR520 in secure
router mode.
Objective:
Configure the initial SR520 and UC500 setup for connectivity. Network address translation (NAT) is
not required on the UC500 in this configuration, because the SR520 manages NAT for the network.
Connect your Cisco UC500 to a Windows PC, as shown
Note: Before proceeding, RESTORE the system to factory default as shown in Appendix A
To Next Page
Loading...
General