LAB 7A: Security on UC500 and SR520
Cisco Unified Communications Technical Training
Page 72 of 171
Configuring the Cisco UC500
To configure the Cisco UC500 using CCA, do the following:
1 Enter the Cisco UC500 LAN IP address in the Connect to field on the Connect window.
2 Enter your Cisco UC500 administrator username and password.
3 Go to Configure > Security > NAT.
4 From the Outside Interface menu on the NAT window, select Delete NAT Settings.
5 Click OK to disable NAT on the UC500. (The Cisco SR520 will NAT incoming and outgoing Internet
traffic; the Cisco UC500 does not require that NAT is enabled.)
To Next Page
Loading...
General