Cisco UCS C220 M3 - Verify Server SKU

Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Large Form Factor Hard Disk Drive Model)
10
BASE SERVER STANDARD CAPABILITIES and FEATURES
Interfaces ■ Rear panel
• One RJ45 serial port connector
• Two USB 2.0 port connectors
• One DB15 VGA connector
• Two RJ-45 10/100/1000 Ethernet port connectors
• One RJ-45 10/100/1000 Ethernet management port, using Cisco Integrated
Management Controller (CIMC) firmware
■ Various PCIe card ports (dependent on which cards are installed)
• Converged Network Adapter (CNA) ports
• Network Interface Card (NIC) ports
• Host Bus Adapter (HBA) ports
■ Front panel
• One KVM console connector (supplies two USB, one VGA, and one serial
connector)
WoL The 1-Gb Base-T Ethernet LAN ports support the wake-on-LAN (WoL) standard.
InfiniBand The bus slots in this server support the InfiniBand architecture.
Front Panel A front panel controller provides status indications and control buttons
Power subsystem Up to two 450 W (AC) , 650 W, (AC), or 930 W (DC) power supplies. One is
mandatory; one more can be added for 1 + 1 redundancy.
ACPI This server supports the advanced configuration and power interface (ACPI) 4.0
standard.
Fans Chassis:
■ Five hot-swappable fans for front-to-rear cooling
Power supply:
■ Each power supply is equipped with a fan.
Integrated
management
processor
BMC running Cisco Integrated Management Controller (CIMC) firmware.
Depending on your CIMC settings, the CIMC can be accessed through the 1-GbE
dedicated management port, the 1-GbE LOM ports, or a Cisco virtual interface
card (VIC).
Capability/Feature Description