Access Interface Connectivity
Configure Access Interface Connectivity
57
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
Quality of Service (QoS) provides preferential treatment to certain types of traffic at the expense of
others. Without QoS, the switch offers best-effort service to each packet, regardless of the packet
contents or size. It sends the packets without any assurance of reliability, delay bounds, or throughput.
Aut0 QoS on the switch generates multiple service policies for various end devices. The service policy
that is generated depends with the end device type.
Step 9 Apply service policies to a single access interface.
The switch then automatically generates the modular QoS command-line interface (MQC) service
policies needed for access.
This example identifies some of the service policy configurations.
Step 10 Apply ingress and egress service policies.
Check the end device-specific configuration to see which service policy is recommended for an end
device.
Verify Access Interface Configurations
This following section describes the commands that you should use to use to confirm that your
configurations in this workflow are correctly applied to your switch:
Step 11 Use the show running-configuration command to verify the operational configuration of the access
interfaces.
auto qos voip cisco-phone
service-policy input AutoQos-4.0-CiscoPhone-Input-Policy
service-policy output 2P6Q3T
To Next Page
Loading...
Need help?
General