Converged Wired and Wireless Access
Enable the Switch as a Wireless Controller
88
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
Enable the Access Point Connections
Step 9 Connect the access points directly to the switch ports to complete installation.
It is mandatory that the access point connection port be configured as an access port. The access point
does not register if the port is configured as a trunk.
Note The access VLAN on the switch port should be the same as the wireless management VLAN configured
in Step 4 in this workflow.
show wireless mobility summary
Mobility Controller Summary:
Mobility Role : Mobility Controller
Mobility Protocol Port : 16666
Mobility Group Name : default
Mobility Oracle IP Address : 0.0.0.0
DTLS Mode : Enabled
Mobility Domain ID for 802.11r : 0xac34
Mobility Keepalive Interval : 10
Mobility Keepalive Count : 3
Mobility Control Message DSCP Value : 48
Mobility Domain Member Count : 3
Link Status is Control Link Status : Data Link Status
Controllers configured in the Mobility Domain:
IP Public IP Group Name Multicast IP Link Status
--------------------------------------------------------------------------
192.168.102.210 -N/A default 0.0.0.0 UP : UP
To Next Page
Loading...
Need help?
General