Cisco WAP4410N - The Setup - Time Tab; Time

WAP4410N User Guide 17
The Setup - Time Tab
Configuring the Wireless-N Access Point
The Setup - Time Tab
This allows you to change the Access Point's time settings. The correct time setting can help the
administrator to search the system log to identify problems.
Time
You can set the time either manually or automatically from a time server if the Access Point can
access the public Internet.
• Manually—Select this radio button to set the date and time manually. The default is to
set the time manually.
• Automatically—Select this option and time zone. The Access Point will contact the
public time server to get the current time. If your location is currently using Daylight
Saving, enable the Automatically adjust clock for Daylight Saving changes
checkbox.
• User Defined NTP Server—Enable this option if you have set up local NTP server.
Default is Disabled.
• NTP Server IP—Enter the IP address of user defined NTP Server.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen.