WAP4410N User Guide 18
The Setup - Advanced Tab
Configuring the Wireless-N Access Point
The Setup - Advanced Tab
This allows you to configure the advanced Setup settings.
HTTP Redirect Settings
You can set the HTTP Redirect to make a web page available under many URLs.
• Enable HTTP Redirect—Enable this in order to make a redirect. Enter the desired URL
in the following field
• 802.1x Supplicant
• Enable 802.1x Supplicant on Ethernet Network—Enable this if your network requires
this AP to use 802.1x authentication in order to operate.
• Authentication via MAC Address—Select this if you want to Use MAC Address for
Authentication.
• Authentication via Name and Password—Select this if you want to use name and
password for Authentication. Enter the Name and Password in the following fields.
Change these settings as described and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen.
To Next Page
Loading...
