The IP ToS Mask value is a two-digit hexadecimal number from 00 to FF. The nonzero-valued bits in the IP
ToS Mask denote the bit positions in the IP ToS Bits value that are used for comparison against the IP ToS
field of a packet.
Step 7 Click OK. The changes are saved to the Startup Configuration.
To delete or modify a class map, select the Traffic Class Name from the list and click Delete or Edit. The
class map cannot be deleted if it is already attached to a policy.
Note
Step 8 Click Apply.
Configuring IPv6 Traffic Classes
To add and configure an IPv6 class map:
Step 1 Select Client QoS > Traffic Classes.
Step 2 Click ✚ to add a Traffic Class.
The maximum number of class maps is 50.
Note
Step 3 In the Traffic Class Name field, enter the name for the new class map. The name can contain from 1 to 31 alphanumeric
and special characters. Spaces are not allowed.
Step 4 Choose IPv6 as the type of Traffic Classes from the list. The IPv6 traffic classes applies only to IPv6 traffic on the WAP
device.
Step 5 Configure the following:
• Source Address — Requires a packet's source IPv6 address to match the IPv6 address defined in the appropriate
fields.
• Any — Any IPv6 address to be used as the source address.
• Single Address — Enter the IPv6 address to apply this criteria.
• Address/ Mask— Enter the prefix length of the source IPv6 address.
• Destination Address — Requires a packet's destination IPv4 address to match the IPv4 address defined in the
appropriate fields.
• Any — Any IPv6 address to be used as the destination address.
• Single Address — Enter the IPv6 address to apply this criteria.
• Address/Mask — Enter the destination IPv6 address and Enter the prefix length of the destination IPv6 address.
Step 6 Click More..., and configure the following parameters:
• Protocol — Uses a Layer 3 or Layer 4 protocol match condition based on the value of the IP Protocol field in IPv4
packets or the Next Header field in IPv6 packets. Choose the protocol to match by keyword or enter a protocol ID:
• All Traffic — Allows all traffic from any protocol.
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
91
Access Control
Configuring IPv6 Traffic Classes
To Next Page
Loading...
