Cisco Wap581 - LAN Status; Wireless Status

LAN Status
Click on the LAN circle to display the following configuration and status settings on the LAN interface.
• MAC Address — The MAC address of the WAP device.
• IP Address — The IP address of the WAP device.
• Subnet Mask — The subnet mask of the WAP device
• Default Gateway — The default gateway of the WAP device.
• Domain Name Server-1 — The IP address of the domain name server 1 used by the WAP device.
• Domain Name Server-2 — The IP address of the domain name server 2 used by the WAP device.
• IPv6 Address — The IPv6 address of the WAP device.
• IPv6 Autoconfigured Global Addresses — The IPv6 autoconfigured global addresses.
• IPv6 Link Local Address — The IPv6 link local address of the WAP device.
• Default IPv6 Gateway — The default IPv6 gateway of the WAP device.
• IPv6-DNS-1 — The IPv6 address of the IPv6 DNS server 1 used by the WAP device.
• IPv6-DNS-2 — The IPv6 address of the IPv6 DNS server 2 used by the WAP device.
These settings apply to the LAN interface. Click Edit to change any of these settings. You will be redirected
to the LAN page.
Click Refresh to refresh the screen and show the most current information.
Click Back to return to the Dashboard page.
Note
Wireless Status
Click the Wireless circle to display the wireless radio interfaces, such as:
• Wireless Radio — The wireless radio mode is enabled or disabled for the radio interface.
• MAC Address — The MAC address associated with the radio interface.
• Mode — The 802.11 mode (a/b/g/n/ac) used by the radio interface.
• Channel — The channel used by the radio interface.
• Operational bandwidth — The operational bandwidth used by the radio interface.
Click Edit to change any of these settings. You will be redirected to the Radio page.
Click Refresh to refresh the screen and show the most current information.
Click Back to return to the Dashboard page.
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
107
Monitor
LAN Status