Cisco Wap581 Administration Guide

CHAPTER 1
Getting Started
This chapter contains the following sections:
• Getting Started with the Configuration, on page 1
• Using the Access Point Setup Wizard, on page 2
• Changing Password, on page 6
• TCP/UDP Service, on page 6
• System Status, on page 7
• Quick Start Configuration, on page 8
• Window Navigation, on page 9
Getting Started with the Configuration
This section describes the system requirements and how to access the web-based Configuration Utility.
Supported Browsers
Before you begin to use the configuration utility, make sure that you have a computer with one of the following
browsers:
• Internet Explorer 11, Microsoft Edge or later
• Firefox 64 or later
• Chrome 72 or later
• Safari 5.1 or later
Browser Restrictions
• If using Internet Explorer 11, configure the following security settings:
• Select Tools, Internet Options and then select the Security tab.
• Next, select Local Intranet and then select Sites.
• Select Advanced and then select Add. Add the intranet address of the WAP device
http://<ip-address> to the local intranet zone. The IP address can also be specified as the
subnet IP address so that all subnet addresses, are added to the local intranet zone.
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
1

Cisco Wap581 Specifications

General

Brand	Cisco
Model	Wap581
Category	Wireless Access Point
Language	English