• The Radio2(2.4GHZ) antenna switches to 2 x2 from 3 x3, TX power decreases to 18dBm.
• The ETH0/PD port downgrades to 1Gbps speed.
• The ETH1 port is turned off.
• System Uptime—The time elapsed since the last reboot.
• System Time—The current system time.
• Firmware Version (Active Image)—The firmware version of the active image.
• Firmware MD5 Checksum (Active Image)—The checksum for the active image.
• Firmware Version (Non-active)—The firmware version of the backup image.
• Firmware MD5 Checksum (Non-active)—The checksum for the backup image.
Quick Start Configuration
To simplify the device configuration through quick navigation, the Getting Started page provides links for
performing common tasks. The Getting Started page is the default window at start-up.
Linked PageLink Name (on the Page)Category
Using the Access Point Setup Wizard, on page 2Setup WizardQuick
Access
Adding a User, on page 29Change Account Password
Configuration Management, on page 13Backup/Restore
Configuration
Firmware, on page 11Upgrade Device Firmware
Radio, on page 45
Wireless SettingsAdvanced
Configuration
System Settings, on page 31Management Setting
IPv4 Configuration, on page 17LAN Setting
Configuring the WAP Device for Single Point Setup, on page
77
Configure Single Point Setup
Guest Access, on page 96Guest Access
Dashboard, on page 105
DashboardMore
Information
TCP/UDP Service, on page 6TCP/UDP Service
View System Log, on page 27View System Log
Traffic Statistics, on page 108Traffic Statistics
For additional information on the device, you can access the product support page or the Cisco Support
Community by:
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
8
Getting Started
Quick Start Configuration
To Next Page
Loading...
Need help?
General
