Cisco Wap581 Administration Guide

CHAPTER 3
System Configuration
This chapter describes how to configure the global system settings and perform diagnostics. It contains the
following topics:
• LAN, on page 17
• Time, on page 23
• Notification, on page 25
• User Accounts, on page 29
• Management, on page 30
• Security, on page 39
LAN
This section describes the process to configure the port, VLAN, LLDP, IPv4, and IPv6 settings on the WAP
device.
IPv4 Configuration
Use the IPv4 Configuration section to configure the IPv4 address.
Step 1 Select LAN > IPv4 Configuration.
Step 2 Configure the following IPv4 settings:
• Connection Type—By default, the DHCP client on the WAP device automatically broadcasts the requests for
network information. If you want to use a static IP address, you must disable the DHCP client and manually configure
the IP address and other network information.
Choose one of the following options:
• DHCP—The WAP device acquires its IP address from a DHCP server on the LAN.
• Static IP—Manually configure the IPv4 address. The IPv4 address should be in a form similar to xxx.xxx.xxx.xxx
(192.168.1.100).
• Static IP Address, Subnet Mask, and Default Gateway—Enter the static IP address, subnet mask and default
gateway.
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
17

Cisco Wap581 Specifications

General

Brand	Cisco
Model	Wap581
Category	Wireless Access Point
Language	English