2
Printer Operation
44
Manually Selecting the Printer Emulation
To manually choose between Datamax
®
and Zebra
®
emulations, you can use
the VuePrint menu system. The Emulation Select option in the System Setup
menu allows you to do this.
Alternatively, you can use the “Quick Switch” option as follows:
1. Turn on the printer holding down PAUSE and FEED keys together.
The printer will beep three times and the CONDITION LED will
flash.
2. Press FEED key once for Datamax
®
emulation.
3. Press FEED key two times for Zebra
®
emulation.
The printer beeps each time the feed key is pressed.
4. To save the new selection, press MODE/REPEAT key. The printer
will beep three times and then restarts.
Menu Setting Table
(p.37, p.40)
To Next Page
Loading...
