Citizen CL-S6621 - Manually.selecting.the.printer.emulation

46
Chapter 2 Printer Operation
Manually Selecting the Printer Emulation
To manually choose between Datamax® and Zebra® emulations, you can
use the VuePrint menu system. The Emulation Select option in the System
Setup menu allows you to do this.
Alternatively, you can use the “Quick Switch” option as follows:
1. Turn on the printer holding down PAUSE and FEED keys
together.
The printer will beep three times and the CONDITION LED
will ash.
2. Press FEED key once for Datamax® emulation.
3. Press FEED key two times for Zebra® emulation.
The printer beeps each time the feed key is pressed.
4. To save the new selection, press MODE/REPEAT key.
The printer will beep three times and then restarts.
Menu Setting Table (p.39, p.42)