CT-S4000 Service Manual
4
INTRODUCTION
This manual describes the disassembly, reassembly, and maintenance procedures of the line thermal
printer CT-S4000.
1. DISASSEMBLY AND REASSEMBLY
Notes the following items when maintaining the printer.
• Do not disassemble, reassemble, or adjust the printer unnecessarily when the printer operation is
satisfactory.
• Do not loosen the screws fixing each component carelessly.
• After finishing inspection, perform checking for normality before turning on the printer.
• Pay attention not to leave the part or screws used for maintenance inside the printer.
• When handling the print head and electronic components, pay attention to static electricity.
• When disassembling or reassembling the printer, check the wiring and cord for damage. Pay
attention not to lay the wiring and cord by force.
• Lubricate the components as necessary when reassembling them.
1.1 Tools Used
• Phillips screwdriver #0, #1, and #2
• Tweezers
• Long-nose pliers
• Oil brush
• Nipper
To Next Page
Loading...
