CT-S4000 Service Manual
7
1.2.2 Disassembling Mechanism Unit
1. Removing UNIT, AUT CUTTER
・Remove two M3x6(ST) screws from both sides.
・Broaden FRAME,MAIN a little and remove UNIT, AUT CUTTER.
* Be sure not to add deformation to FRAME, MAIN by broadening excessively.
2. Removing LEVER, COVER LOCK2
・Remove SPRING, COVER LOCK LEVER from LEVER, COVER LOCK1.
・Remove one M3x6(ST) screw.
・From FRAME, MAIN remove LEVER, COVER LOCK1.
3. Removing HOLDER, SPRING HEAD
・Broaden FRAME, MAIN a little and remove HOLDER, SPRING HEAD.
* Be careful not to add excessive deformation to FRAME, MAIN.
* Be sure not to have SPRING, HEAD lost in removal.
4. Removing SA HEAD
・Broaden FRAME, MAIN a little and remove SA HEAD.
* Be careful not to add excessive deformation to FRAME, MAIN.
SPRING, COVER LOCK LEVER
M3x6 (ST)
LEVER, COVER
LOCK1
Remove in arrow
direction.
HOLDER, SPRING HEAD
SA HEAD
To Next Page
Loading...
