Citizen CT-S4500 - 3.14 Selecting a Paper Type

59
——
3.14 Selecting a Paper Type
Paper type selection is available by the combination of memory switches MSW4-4
and MSW4-5 by the used of “Memory Switch Select Mode”. In addtion, the following
procedure is available.
1. Enter Selecting Paper Type mode.
1) With the top cover open, turn on the printer power switch while pressing and holding the
FEED key.
The buzzer sounds and the status LED ashes in green.
2) Remove your nger from the FEED key briey, and then press the FEED key three times in
succession.
Next, closing the top cover causes the buzzer to sound briey three times. The type of
paper currently selected is represented by the status display LEDs.
2. Select Paper Type.
Press the FEED key to match the paper used with the paper type displayed by the status
display LED.
(Refer to the table below.)
Paper Status LED
Label media Green
Press the FEED key ↓
Thermal roll paper Amber
Press the FEED key ↓
Black mark paper Red
Returns to label paper selection.
3. Save the selected Paper Type to the Printer.
Open the top cover and then close it as it is.
The paper type selected is stored in the printer memory switch as shown in the table below.
The paper type setting mode nishes and the printer restarts automatically.
Paper type MSW
4-4 4-5
Thermal roll paper Thermal roll paper -
Black mark paper Black mark paper/label media Black mark detection
Label media Black mark paper/label media Label gap detection