75
——
CAUTION
Make sure the cut position is between labels.
Cut the backing paper. Do not cut label paper (tack paper).
Always re-calibrate the paper sensor whenever you change the label backing paper type.
Do not use full-surface label media.
Rolled with the printable side out.
For roll paper end processing, do not glue the roll paper to the core.
Also, do not fold the end.
Black mark paper
direction
Cut position
A
B
C
D
F
G
Black mark
(Reverse side)
Printable area
(Unit: mm)
Mark Item
Dimensions
Minimum Maximum
A Left edge of black mark 15 66.5
B Right edge of black mark 0 51.5
A-B Black mark width 15 -
C Black mark height 4 17.8
D Cut position in black mark Center in height direction ±2
E Top margin 2+2/-2
F Black mark pitch 30 to 300
G Bottom margin 0±1
To Next Page
Loading...
