81
——
Switch no. Function Initial setting Setting value
MSW10-1 Print Density 100 % 70 %, 75 %, 80 %, 85 %, 90 %, 95 %, 100 %, 105 %,
110 %, 115 %, 120 %, 125 %, 130 %, 135 %, 140 %
MSW10-2 Print Speed Level 9 Level 5, Level 6, Level 7, Level 8, Level 9
MSW10-4 Old Command Invalid Invalid, CBM1, CBM2
MSW10-5 Buzzer Event Not By C.
Open
All Event/Error, Not by C.Open, Not by C.Open/PE
MSW10-6 Buzzer Sound Tone 2 Tone 1, Tone 2, Tone 3, Tone 4
MSW13-1 Security/Target Low/All Low/All, Mid/All, Mid/Paired only, Hi/All, Hi/Paired only
MSW13-5 BT Device Scan Discoverable No Response, Discoverable
MSW13-6 Auto Reconnect Valid Valid | Invalid, Valid
*1: These settings are enabled only when MSW4-4 is set to black mark paper / label paper.
*2: If MSW2-2 is disabled, the cut action is not performed regardless of the setting of MSW4-3.
*3: When black mark paper / label paper is used (MSW4-4 is ON), the media is fully cut regardless of the setting
of MSW4-8. Furthermore, if the length of the label to be used is 37 mm or less, feeding and cutting is
performed when the power turns on even if MSW4-2 is OFF.
To Next Page
Loading...
