CT-S651 Series Service Manual
- 18 -
Remove “WASHER, PLATEN” from the “COVER, CABLE-02” side, and remove “SA, FRAME COVER
UNIT-02” from the hinged section at “SA, MAIN FRAME”. When removing “SA, FRAME COVER
UNIT-02”, make sure that “SA, FRAME COVER UNIT-02” is opened and that no load is applied to
“SPRING, COVEROPEN-02”.
<Precaution at disassembly / reassembly>
When reassembling, check the orientation of “SPRING, COVEROPEN-02”. Attach the bent side to the hook
at the “SA, MAIN FRAME” side, and attach the other side to the hook at the “SA, FRAME COVER UNIT-02”
side.
8. Disassembling “COVER, CABLE-02”
Remove “SCREW, PHT (ST), M2.0 × 4” that fastens “SA, FRAME COVER UNIT-02” and “COVER,
CABLE-02”, and slide “COVER, CABLE-02” sideways to detach the hooks. Then pull out “COVER,
CABLE-02”.
WASHER, PLATEN
SPRING, COVEROPEN-02
With bend
SCREW, PHT (ST), M2.0 × 4
COVER CABLE-02
To Next Page
Loading...
