Citizen CT-S651 Series

CT-S651 Series Service Manual
- 20 -
10. Disassembling “PLATE, FIX BLADE”
Remove two “SCREW, PHT (ST, SW + PW), M3.0 × 6” that fasten “FRAME COVER UNIT-02”, “PLATE,
FIXED BLADE” and “GUIDE, PAPER-02”.
<Precaution at reassembly>
When reassembling, align “GUIDE, PAPE-02” with the boss at “SA, FRAME COVER UNIT-02”.
Keep the chamfered side of “PLATE, FIXED BLADE” at the left so that the alignment mark at “SA, FRAME
COVER UNIT-0” can be seen.
11. Disassembling “GUIDE, HEAD HOLDER-02”
Remove three “SPRING, HEAD-02” from “SA, FRAME COVER UNIT-02”.
<Precaution at disassembly / reassembly>
The photo shows the position for the 3-inch model.
“2” marked on “GUIDE, HEAD HOLDER” indicates
the position for the 2-inch model, and “3” indicates
the one for the 3-inch model.
Insert the spring into the boss at “SA, FRAME
COVER UNIT-02” and check that the spring cannot
be removed even if it is pulled lightly.
SCREW, PHT (ST, SW + PW), M3.0 × 6
GUIDE, PAPER-02
PLATE, FIXED BLADE