Citrix ADC MPX 5550 - Page 202

Citrix ADC MPX
• rc.local_disk_wipe_2
• rc.local_flash_wipe_1
• rc.main_disk_wipe
• rc.main_flash_wipe
• rc.system_wipe_and_reset
Commands to wipe the config
At the command line, type:
1 > shell
2 # cd /flash/.recovery
3 # sh rc.system_wipe_and_reset
4 <!--NeedCopy-->
Two optional parameters are available to zero the flash and the disk one or more times.
1 sh rc.system_wipe_and_reset [num_flash_loops [num_disk_loops]]
2 <!--NeedCopy-->
Parameters:
• num_flash_loops - Number of times to loop through the flash, zeroing all sectors. The default
is 0. Acceptable values are from 0 through 16.
• num_disk_loops - Number of times to loop through the hard drive, zeroing all sectors. The
default is 0. Acceptable values are from 0 through 16.
Note: You can specify num_disk_loops only aer you provide num_flash_loops. To zero the disk with-
out zeroing the flash, set the flash parameter to 0.
Examples
The following command is used to zero the flash once and zero the hard drive twice.
1 sh rc.system_wipe_and_reset 1 2
2 <!--NeedCopy-->
The following command is used to zero only the hard drive once.
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 202