Citrix ADC MPX 5550 User Manual

Citrix ADC MPX
Specify an SNMP community string name
At the prompt, type:
ipmitool lan set 1 snmp <community string>
Install a certificate and key on the LOM GUI
September 19, 2022
Citrix recommends using HTTPS to access the LOM GUI. To use HTTPS, you must replace the default
SSL certificate with one from a trusted certificate authority and upload a private key to the LOM GUI.
To encrypt SNMP alerts, set up an SSL certificate and private key. In the GUI, navigate to Configu-
ration > SSL Certification and apply the SSL certificate and private key. See the Citrix ADC Secure
Deployment Guide for more information about how to securely deploy the LOM in your network. To
enable encryption and learn the security measures for LOM, see Citrix ADC Secure Deployment Guide.
If you make a mistake, you must restore the BMC to the factory defaults to erase the certificate and
key. Use the following shell command:
1 ipmitool raw 0x30 0x40
2 <!--NeedCopy-->
Note: The certificate file must contain only the certificate. The certificate and key must not be in the
same file. Make sure that the certificate contains only the certificate and that the key file contains only
the key.
Upload a trusted certificate and private key by using the LOM GUI
1. Navigate to Configuration > SSL Certification.
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 166

Citrix ADC MPX 5550 Specifications

General

Brand	Citrix
Model	ADC MPX 5550
Category	Network Hardware
Language	English