Citrix ADC MPX
The following components are visible on the back panel of the MPX 17550/19550/20550/21550 appli-
ance:
• 160 GB or larger removable solid-state drive that is used to store the Citrix ADC soware.
Note: Drive densities might increase as components become EOL but its size is never smaller
than the original.
• USB port (reserved for a future release).
• Power switch, which turns o power to the appliance, as if you were to unplug the power supply.
Press the switch for five seconds to shut o the power.
• Non-maskable interrupt (NMI) button that is used at the request of Technical Support and pro-
duces a core dump on the appliance. Use a pen, pencil, or other pointed object to press this red
button, which is recessed to prevent unintentional activation.
• Two removable hard-disk drives that store user data.
• Disable alarm button. This button is functional only when the appliance has two power sup-
plies.
Press this button to stopthe power alarm from sounding when either of the following conditions
is true:
– You have plugged the appliance into only one power outlet.
– One power supply is malfunctioning, and you want to continue operating the appliance
until it is repaired.
• Two power supplies, each rated at 960 watts, 110–220 volts. Maximum power consumption is
850 watts. Typical power consumption is 570 watts.
For information about installing the rails, rack mounting the hardware, and connecting the cables,
see Installing the Hardware.
For information about performing the initial configuration of your appliance, see Initial Configuration.
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 75
To Next Page
Loading...
Need help?
General
