74
II
If any of these instances arises, contact a CITROËN dealer as soon as possible.
ELECTRONIC PARKING BRAKE - OPERATING ANOMALIES
SITUATION CONSEQUENCES
4
Display of message «
Parking brake faulty
»
and the following warning lamps :
and/or flashing
- The automatic functions are deactivated.
- The hill start assist is unavailable.
To apply the electronic parking brake :
1. Immobilise the vehicle and switch off the ignition.
2. Pull the control lever for at least 5 seconds or until
maximum application.
3. Switch on the ignition and check that the electronic
parking brake warning lamps are on.
Note : - Application may take longer than in normal operation.
- If warning lamp P flashes or if the warning lamps do not
come on when the ignition is switched on, this method
does not work. Contact a CITROËN dealer.
To release the electronic parking brake :
1. Switch on the ignition.
2. Pull the control lever and hold it for approximately
3 seconds.
5
Display of message « Parking brake con-
trol faulty – automatic mode activated »
and the following warning lamps :
and/or flashing
- Only the functions for automatic application on switching off
the engine and automatic release on acceleration are avail-
able.
- Manual application/release of the electronic parking brake
and dynamic emergency braking are unavailable.
6
Battery fault - Lighting of the battery warning lamp makes it essential to
stop the vehicle as soon as traffic allows. Stop and immobi-
lise your vehicle.
- Apply the electronic parking brake before switching off the
engine.
To Next Page
Loading...
