II
89
Stopping the function
- by an action on the control on
position «REG» to position 0.
- by the engine stopping.
The cruise speed previously cho-
sen is no longer memorised.
If there is a malfunction, a mes-
sage will display accompanied by
a sound signal and lighting of the
SERVICE warning lamp.
Contact a CITROËN dealer.
Cruise control should only be used when the
driving conditions allow you to drive at a
constant speed.
Do not use it in heavy traffic, or on dangerous or
slippery roads.
The driver must remain attentive and in full control of his vehicle.
You are recommended to keep your feet within range
of the pedals.
Re-engaging cruise control
- by recall of the memorised
speed :
After a disengagement, press on
button 3. Your vehicle automati-
cally returns to the memorised
cruise speed which is displayed
in zone A.
If the memorised cruise speed is
higher than the current speed, the
vehicle wll accelerate to reach the
former.
- by selection of the current
speed :
Press on button 2 or 4 once the
desired speed has been reached.
The information «OFF» will then
disappear from zone A.
Observation : If during the opera-
tion of cruise control, the system is
unable to keep within the memo-
rised speed (for example on a steep
descent), then the speed flashes.
Adapt your speed as necessary.
Disengaging of cruise control
while retaining the memorised
speed
- Either by pressing on the brake
pedal or on the clutch pedal.
- Or by pressing button 3.
- Or if either the ESP or the ASR
system is active.
Note : cruise control is not active if
the gear lever is in neutral.
These actions cause the informa-
tion «OFF» to appear in zone A of
the instrument panel.
These manœuvres do not cancel
the cruise speed which remains
displayed in the instrument panel.
CRUISE CONTROL
To Next Page
Loading...
Need help?
General
