CITROEN 2015 Berlingo Multispace - Page 178

176
Berlingo-2-VP_en_Chap08_Aide-rapide_ed02-2015
Changing a wheel
Berlingo-2-VP_en_Chap08_Aide-rapide_ed02-2015
FITTING THE WHEEL TRIM
Thetyrevalvemustbecentredinthe
wheeltrimcut-out.
Thispositionisessentialforttingthe
wheeltrimcorrectlyonthesteelwheel.
(If the valve is not correctly aligned with
thecut-out,theanti-rotationsystem
will be in contact with the heads of the
wheelboltsandrisksbeingdamaged
iftheuserpersistsinttingthewheel
triminthisincorrectposition).
- Ensure that all of the clips are
engaged except the last one
(oppositethevalvehole).
- Strikethewheeltrimwiththepalm
of your hand, opposite the valve
intheareaofthelastxingclip
(alwaysinthedirectionofclipping).
- Ensure that the outer edge of
thewheeltrimisnotdeformedor
pushedintothewheel:
● Correct position for the edge of
thewheeltrim.
● Incorrect position for the edge of
thewheeltrim.
6. Refitting the repaired wheel
Thewheelisrettedasdescribedin
step5,notforgettingtoretthewheel
trim.
Refertothe"Instrumentsand
controls" section of chapter 3,
"Tyreunder-inationdetection"
part,forrecommendationsafter
changingawheelttedwithatyre
under-inationdetectionsensor.
Refertothe"Identication
markings"sectionofchapter9to
locatethetyrelabel.
The spare wheel is not designed
tobeusedoverlongdistances.
Have the tightening of the bolts
andthetyrepressurecheckedby
aCITROËNdealeroraqualied
workshopassoonaspossible.
Have the original wheel repaired
andrettedbyaCITROËNdealer
oraqualiedworkshopassoonas
possible.