CLUTCH SPECIFICATION
NOTE : All the clutches are «push» type with hydraulic control.
Description.
The declutch control has a declutch fork mounted on a ball-joint.
(1) The ball-joint is screwed into the clutch casing.
(2) Declutch fork.
(3) Clutch casing.
(4) Bearing.
(5) Clutch plate.
The clutch control slave cylinder (7) is fixed by two screws (6) onto the exterior of the clutch casing.
It has a bleed screw (8).
T
ightening torques (m.daN).
- Fixing of clutch plate/engine flywheel : 1.2 ± 0.2 (HFX -KFV) 2 ± 0.2 (NFU)
- Fixing of engine flywheel/crankshaft
Pre-tightening : 1.7 ± 0.1
Angular tightening : 70° ± 5°
B2BP047C B2BP04QC
CLUTCH
GEARBOX
DRIVESHAFTS
130
CLUTCH
GEARBOX
DRIVESHAFTS
To Next Page
Loading...
