CITROEN C2 2003 - Markings on the Dynamic Tensioner Roller

54
AUXILIARY EQUIPMENT DRIVE BELT
Engine : 8HX
Markings on the dynamic tensioner roller
.
«a» Position of «maximum wear» of the auxiliary drive belt.
«b» Normal position.
Refitting
NOTE : Check that the tensioner roller moves freely (no tight spot). If this is not the
case, replace the tensioner roller.
Respect the direction of fitting of the drive belt.
Complete the setting of the belt, of both sides, by means of the tensioner roller.
Make sure that the drive belt is correctly positioned in the «V» grooves of the
various pulleys.
Move the tool [2] on the tensioner roller to remove the peg [3].
ENGINE
B1EP18UD