CITROEN C2 2003 - Page 76

74
CHECKING AND SETTING THE VALVE TIMING
Engine : 8HX
B1EP18LC B1BP2LZC
Setting the timing (continued).
Refit:
The intermediate RH engine support, tighten the screws (16) to 5,5 ± 0,5 m.daN.
The RH engine support, tighten the screws (17) to 4,5 ± 0,4 m.daN.
The bottom timing cover (3).
Immobilise the engine flywheel, using tool [3].
Remove the screw (2).
Refit the accessories drive pulley and tighten to:
Pre-tighten to : 3 ± 0,3 m.daN.
Angular tighten to : 180° ± 1,8°
Remove tool [3]
Refit:
The top cover (1).
The accessories belt (see corresponding operation).
The exhaust line (see corresponding operation).
The front RH splash-shield.
The front RH wheel.
ENGINE