CITROEN C3 2022 - Automatic illumination of lamps

47
Lighting and visibility
4
If the driver's door is opened, a temporary
audible signal warns the driver that the lamps
are on.
The lamps, with the exception of the
sidelamps, switch o󰀨 automatically after a
maximum duration of 30 minutes to avoid
draining the battery.
Switching o󰀨 of the lamps when the
ignition is switched o󰀨
When the ignition is switched o󰀨, all of the
lamps turn o󰀨 immediately, except for dipped
beam headlamps if automatic guide-me-home
lighting is activated.
In some weather conditions (e.g. low
temperature or humidity), misting on the
internal surface of the glass of the headlamps
and rear lamps is normal, and will disappear
after the lamps have been on for a few
minutes.
Never look too closely at the light beam
of LED technology lamps - risk of serious
eye injury!
Travelling abroad
Vehicles equipped with light-emitting
diode (LED) headlamps:
If planning to use your vehicle in a country
that drives on the other side of the road, the
dipped beam headlamps must be adjusted to
avoid dazzling oncoming drivers. Contact a
CITROËN dealer or a qualied workshop.
Direction indicators
► Left or right: lower or raise the lighting control
stalk, beyond the point of resistance.
If you keep the direction indicators on for
more than 20 seconds, the volume of the
audible signal will increase if the speed is
above 50 mph (80 km/h).
Three ashes
► Press briey upwards or downwards, without
going beyond the point of resistance; the
direction indicators will ash 3 times.
Parking lamps
(Depending on version)
Vehicle side marking by lighting the sidelamps
on the tra󰀩c side only.
► Within one minute after switching o󰀨 the
ignition, operate the lighting control stalk
upwards or downwards, depending on the side
of the tra󰀩c (e.g. when parking on the right, push
the lighting control stalk down to light up on the
left).
This is conrmed by an audible signal and the
lighting of the corresponding direction indicator
lamp on the instrument panel.
► To switch o󰀨 the parking lamps, return the
lighting control stalk to the central position.
Automatic illumination of
lamps
With the lighting control stalk in the “AUTO”
position and if a low level of exterior brightness
is detected by the rain/sunshine sensor, the
number plate lamps, sidelamps and dipped
beam headlamps are switched on automatically,
without any action on the part of the driver. They
may also come on if rain is detected, at the same