CITROEN C6 2007 - G R O U N D C L E a R a N C E a D J U S T M E N T

102
III
G R O U N D C L E A R A N C E A D J U S T M E N T
Position changes may only be
made when the engine is running.
The ground clearance is adjusted
automatically. You can however
modify the vehicle height in certain
specifi c cases.
To change the position
Press once on one of the adjust-
ment controls. The change of posi-
tion is indicated at the start of the
adjustment by:
A
message or
A
Temporary
display of the initial
position with the symbol for the
position requested.
Note:
You are recommended to
avoid any changing of position
while you have your foot on the
brake.
Viewing of the position of
the vehicle
On completion of the adjustment
you see either a message or an
illustration of the position attained
by the vehicle, with the appropriate
symbol.
•
•
Maximum height
Changing a wheel.
Intermediate position
For an increased ground clear-
ance.
For use on diffi cult roads when trav-
elling at reduced speed, as well as
on carpark ramps.
Normal road position
Minimum height
To facilitate loading or unloadng the
vehicle.
For workshop inspections.
Not to be used in normal driving.
For your safety if you are operating underneath the vehicle, it
is obligatory to support the vehicle with axle stands.
Display of the position requested confi rms the completion of
the adjustment.