CITROEN C6 2007 - S E at B E Lt S W a R N I N G L a M P; Operation

31
II
2
3
1
S E AT B E LT S WA R N I N G L A M P
OPERATION
The driver's and the front and rear
passengers' seats have sensors
that detect non-fastening/unfas-
tening of the seat belts.
The fastened/non-fastened status
of the seat belts for each type of
seat is indicated by the illumination
or fl ashing of the warning lamps
1
,
2
and
3
.
FUNCTIONING OF THE SYSTEM OF DETECTION
Driver's and front passenger's seats
When you switch on the ignition:
If
the driver's seat belt is not fastened, the warning lamp
If
1
illuminates in
the instrument panel.
If
the passenger's seat belt is not fastened, the warning lamp
If
3
lights
up.
Above 20 km / h (12 mph), if the seat belt is unfastened the warning lamp
fl ashes, accompanied by a message and a sound signal for around 2 min-
utes. After that, warning lamps
1
and/or
3
remain on.
Rear passengers' seats
When you switch on the ignition, warning lamp
2
lights up to make the driver
and any passengers aware.
Once the doors are closed and the engine started, a message tells you the
fastening status of the rear belts for 30 seconds.
After this time, if one or more of the rear belts are not fastened:
The
warning lamp
2
comes on if your speed is less than approx. 20 km
/
h
(12 mph).
The
warning lamp
2
fl ashes, accompanied by a message and a sound
signal, for about two minutes if your speed is greater than around 20 km / h
(12 mph).
Note:
The
detection of non-fastening of rear seat belts is deactivated when you
switch off the ignition or if one of the vehicle's doors is opened.
A
child seat installed on the front passenger's seat may not be
detected.
•
•
•
•
•
•
The driver
, after he has closed the doors and started the engine,
must
make sure
that the passengers:
Have
all
fastened their seat belts
Are
using the seat belts
correctly
.
•
•