103
AXLES
SUSPENSION
STEERING
AXLE GEOMETRY (SETTING AT REFERENCE HEIGHT)
Tools.
[1] Set of two suspension compressors : 9511-T.A
[2] Set of two shackles : 9511-T.C
[3] Under body height gauge : 2305-T
[4] Set of two straps : 9511-T.B
[5] Set of two slings : 9511-T.D
The front tracking can be checked and adjusted in running order (Systematic use of two tyres).
To check all the angles, it is necessary to set the vehicle at reference height (Castor, camber, tracking).
Setting at reference height.
Requirements prior to setting at reference height.
WARNING : The checks of the front and rear axle geometry values, as well as the adjusting of the front suspension should be carried out at precise
positions of suspension compression (reference height) on a suspension test bed.
Make sure that :
- Tyres are in conformity and at the correct inflation pressures.
- The front wheels are straight ahead.
Remove wheel trims.
To Next Page
Loading...
