CITROEN C8 2002 - Hydraulic Clutch Control: Bleeding and Circuit Composition; Hydraulic Clutch Control Bleeding; Hydraulic Circuit Composition

79
HYDRAULIC CLUTCH CONTROL SPECIFICATION
CLUTCH
GEARBOX
DRIVESHAFTS
Engines : RFN-3FZ-RHT-RHW-4HW
Bleeding the hydraulic clutch control.
Composition of the hydraulic circuit.
- Brake fluid reservoir located on the master cylinder.
- Hydraulic control sender located in the passenger compartment and fixed on the pedal gear.
- Clutch pedal.
- Hydraulic control receiver fixed on or inside the clutch housing, depending on gearbox type.
Bleed.
IMPERATIVE : Use only new, clear brake fluid, avoid entry of any foreign bodies or impurities into the hydraulic circuit.
Use only hydraulic fluid that is approved and recommended : DOT4.
IMPERATIVE : Do not use any automatic bleed apparatus (risk of the fluid emulsifying in the reservoir).
Remove:
- The pollen filter and its support (see corresponding operation in chapter on aircon).
- The air filter and its union.
- The under-engine sound-deadening.
Refill the brake fluid reservoir to the maximum of its capacity.