CITROEN C8 2002 - 4 HW Auxiliary Drive Belt Service; Tools for Drive Belt Service; Drive Belt Removal Procedure; Drive Belt Rotation Marking

35
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT
Engine : RHT - RHW
Tools.
[1] Tensioning lever : (-).0188-J2.
[2] Peg for dynamic roller Ø 4 mm : (-) 0188-Q1.
[3] Peg for dynamic roller Ø 2 mm : (-).0188-Q2.
[4] Dynamic roller compression lever : (-).1888-Z.
(A) Pegging hole.
(B) Belt wear check mark (fixed on engine).
(C) Zero wear mark.
(D) Maximum wear mark.
This marking system permits checking of the belt wear; if the marks (D) and (B) coincide, it implies that the belt
requires replacing.
Tighten the screw (1) to 4.5 ± 0.4 m.daN.
Removing
Remove:
- The front RH wheel.
- The front RH splash-shield.
- The under-engine shield.
IMPERATIVE : Mark the direction of rotation of the belt if to be re-used.
E5AK0E9C
B3EK0DHD