43
CHECKING AND SETTING THE VALVE TIMING
Engine : RFN
Refitting.
Systematically replace the timing belt.
IMPERATIVE : Check that the rollers (9) and (11), as well as the coolant pump (12) turn freely (no
tight spot).
When replacing the belt (11), tighten the fixing to 3.5 ± 0.3 m.daN.
Position the belt on the crankshaft pinion (13), respecting its direction of fitting.
Immobilise the belt, using tool [3].
Refit the timing belt, well-tensioned, in the following sequence:
- Guide roller (11).
- Pinions (14) and (15).
- Coolant pump (12).
- Tensioner roller (9).
B1EK1T8D
ENGINE
To Next Page
Loading...
