81
HYDRAULIC CLUTCH CONTROL SPECIFICATION
CLUTCH
GEARBOX
DRIVESHAFTS
Engines : RFN-3FZ-RHT-RHW-4HW
B2BK065C
Bleeding the hydraulic clutch control (continued).
Top up the brake fluid level to the MAXIMUM of the brake fluid reservoir capacity.
Declutch and clutch rapidly 40 times.
Start the engine.
Apply the handbrake.
Engage a gear.
Check that the clutch starts to engage at a dimension (X) greater than or equal to 35 mm
(Dimension (X) is given as a guide).
NOTE : If incorrect, repeat the bleed operations.
Tighten the bleed screw (1) to 0.75.m.daN.
To Next Page
Loading...
