CITROEN CX 2000 - Page 382

OPERATION NO MA. 840-O : Adjjrrsting the body-shell rompovcnts
Op. MA. 840.0
1
ADJUSTING THE BODY-SHELL COMPONENTS
t
Jl
-
- Clearance between wings and bonnet
Jl.- 6; F.5 rnrn
Difference between left and right-hand sides
2.smm “lox.
Difference in level between wings and bonnet
2 mm max.
- - Flush fit tolerance between wings and bonnet .,
Ll = 2 mm mox
E
- Longitudinal adjustment of bonnet : measurement between front end of bonnet
E
and front end of wings
.,,,,,, ,., L2 = 0 t 3 mm
- Clearance between rear wings and boot lid ......................................
....................
J2 = 6 + 2.5 mm
-1
Difference in level between the left and right-hand sides
............................... 2 mm max
Difference in level between wings and
boot
lid .............................................
1.5 mm max
- Clearance between upper edge of boot lid and rear window
.............................. J3 = 6.5 ? 4 mm
Difference in level between boot lid and rear window
....................... ......... 3 mm max
- Clearance between boot lid rind rem irXI,p cluster ......................
,, ., ............ J4 = 6 + 2.5 mm
-1
- Clearance between rem bumper and lower edge of boot lid
....................... ............
55 = 10 mm