2 OPERATION No MA. 840-O : A//ii,rs/hq /I><. body-sbcll rom/mncnts
Section A
Section C
Section 8
4-k
J4
Clearance b&men side panels :
- Clearance between panels
Jl = J2 = J3 = 6 + 3 mm
Difference in level between edges of panels
2 mm max.
- Clearance between window frames of the front and rear doors
J4
= 10 + 2 mm
Difference in level ( between window frames ) .,., 2 EN? max.
_ Clearance between side window frames and roof edge
J5 = 7 ? 2 mm
- Difference in level ( between window frames and roof )
2 mm max
- Clearance between door and
rubber
seal fixings
J6 = 14 + 2 mm
-4
Flush-fit tolerances :
Protrusion of each component in relation to the one immediately
behind it
0 to 2 mm max
..,.................,,,II,
- Continuity of the s< light line >a Difference
2 mm max.
- Recess of side door window frames in relation to roof gutter R = .7 ’ 4 mm
-2
To Next Page
Loading...
