Claas DISCO 3000TRC - Diagnosis of Angle Transmitter

TIC LINER Hydraulic / Electric System
10/04 4-29
1.6.5 Diagnosis of angle
transmitter
After switching on the control terminal, the angle transmitters are
automatically tested:
LED 10 lights up: no fault
LED 10 flashing once: front angle transmitter defective
LED 10 flashing twice: rear angle transmitter defective.
LED 10 flashing three times: both angle transmitters defective.
The flashing mode is repeated every 15 seconds.
Chassis Reed contact
switch
(from serial no.)