EasyManuals Logo

Clack WS2 series User Manual

Default Icon
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
WS1, 1.5 & 2 Series Watersoftener
Installation Operation Maintenance Manual
SIMPWS1 REV3 13/07/11 PAGE 14 OF27
8.0 ROUTINE MONITORING
The following recommendations are made to help the user of the
softener confirm that it is performing as required, and to give early
warning of possible problems. The operation of the softener is
completely automatic, and should not require adjustment.
Weekly
Check the treated water hardness with a hardness test kit.
Inspect the level of salt in the salt tank and refill if necessary.
Monthly
Check raw water hardness, and record. Compare with original
hardness and adjust volume capacity setting if required (see Section
12.0).
Annually
Inspect and clean/replace as necessary the brine injector, brine screen
and the inernal disc/flapper set. This should be performed by a
competent engineer familiar with the WS1 valve.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clack WS2 series and is the answer not in the manual?

Clack WS2 series Specifications

General IconGeneral
Model SeriesWS2
Pressure Rating125 PSI
MeteredYes
Time ClockYes
Regeneration TypeDownflow or Upflow
Cycle AdjustmentYes
Materials of ConstructionNoryl
TypeWater Softener
Flow Rate12 GPM
Control ValveFleck 5600
Valve Size1"

Related product manuals