10
English
5. OPERATIONS
Basic Operations
Note:
• Refer to the diagrams in “3. CONTROLS”
when reading this chapter.
CAUTION
Whentheunitisturnedon,startingand
stoppingtheenginewithitsvolume
raisedtothemaximumlevelmayharm
yourhearings.
Becarefulaboutadjustingthevolume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car’s battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [SRC /
] button on the front
panel to turn on the power under standby
mode. The unit goes back to the last
status after power on.
3. Press and hold the [SRC / ] button on
the front panel to turn off the power.
CT (Clock Time) display
• The displayed clock data is based on the
CT (clock time) data in the RDS signal.
Mute
Press the [MUTE] button on the remote
control to mute the volume from the unit.
Note:
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the [VOLUME] knob on the front panel
or press the [ ] or [ ] button on the
remote control.
The adjustable range of volume is 0 to 40.
CAUTION
Whiledriving,keepthevolumelevelat
whichexternalsoundscanbeheard.
Playing source selection
Press [SRC / ] button on the front panel
or [SRC] button on the remote control
repeatedly to choose desired playing source.
Notes:
• Playing source selection means selecting
work mode, such as DISC mode, RADIO
mode and AUX mode, etc.
Display system time
Press the [D] button on the front panel
or [DISP] button on the remote control to
switch the display information between RDS
information, system time and playing source.
RESET
Note:
* When the [RESET] button is pressed,
frequencies of radio stations, titles, etc.
stored in memory are cleared.
RESET
Downloaded from Caradio-Manual.com Manuals