Water droplets may form on Let dry for about 1 hour with the power on
the internal lens when the
car is parked in a humid
place
Compact disc is heavily
scratched or warped
Compact disc Another compact disc is
cannot be loaded already loaded
~setbUtlOn
Replace with a fuse of the same amperage If the
fuse blows again, consult your store of purchase
Consult your store of purchase
1 Turn the unit off
2 Remove all wires attached to the power antenna
lead Check each wire for a possible short to
ground using an ohm meter
3 Turn the unit back on
4 Reconnect each amplifier remote wire to the
power antenna lead one by one If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required)
Turn off the power, then press the RELEAS button
!IJ
and remove the DCR
Press the reset button for about 2 seconds with a thin
rod
Eject the compact disc before loading the new one
Replace with a compact disc with no scratches
Clean the compact disc with a soft cloth
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol
Incorrect wiring
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna
The microprocessor has
malfunctioned due to noise,
etc
Compact disc is dirty
DCP or source unit
connectors are dirty
Power does not
turn on
(No sound is
produced)
No sound output
when operating
the unit with
amplifiers or
power antenna
attached
Nothing happens
when buttons are
pressed
Sound is bad
directly after
power is turned
on
32
DXZ715/HX-D10
To Next Page
Loading...
Need help?
General
