Adjusting
the
filter
frequencies
of
speakers
(HPF/SUB-W LPF)
This function allows you to adjust the filter
frequency matched to the speakers you are
using.
• The filters (HPF/SUB-W LPF) that you can
use differ according to the Dolby Pro Logic
II
mode setting.
Dolby
Pro
Logic
II
Filter
mode setting HPF
SUB-W
LPF*1
MUSIC
/
MATRIX
Not adjustable
Adjustable
OFF Adjustable
Adjustable
*1
Adjustment is possible only when
"SUB-WOOFER" is set to "ON".
• The factory default setting
is
"THROUGH".
• Filter adjustment
• HPF
(high-pass
filter
adjustment)
This filter cuts bass sound from the front and
rear speakers.
THROUGH
~
50Hz
~
80Hz
~
120Hz
Set the filter matched to the speaker when
small-diameter speakers are used.
THROUGH
Set this when using speakers that can
generate bass.
• SUB-W LPF
(sub-woofer
low-pass
filter
adjustment)
This filter cuts treble sound from the sub-woofer.
THROUGH
~
50Hz
~
80Hz
~
120Hz
Set the filter frequency to match the sub-woofer.
THROUGH
Set this when a low-pass filter built-in
powered sub-woofer is used.
1.
Press the [A] button to set to the adjust
mode.
2.
Touch "t
IJ
1"
on the setting item display to
select "HPF" under "SOUND" and "SUB-W
LPF" under "SOUND".
3.
Either touch "t
IJ
1"
on the right of the
display, or turn the [ROTARY] knob to set
the frequency.
* Select one of THROUGH, 50Hz, 80Hz,
and 120Hz.
Operations
Common
to Each Mode
4.
Press the [A] button to return to the original
mode.
Setting
internal
amplifier
use
ON/OFF(AMP CANCEL)
Set internal amplifier use ON/OFF matched to
whether or not an external amplifier is used.
Set AMP CANCEL to "ON" (internal amplifier
use OFF) when an external amplifier is
connected and the internal amplifier is not used.
• The factory default setting is "OFF" (internal
amplifier used).
1.
Press the
[A]
button to set to the adjust
mode.
2.
Touch "t
IJ
1"
on the setting item display to
select "AMP CANCEL" under "SOUND".
ADJUSTJIIIODE
AMP
CANCEL»
OFF
3. Either touch "t1J1" on the right of the
display, or turn the [ROTARY] knob to select
"ON" or "OFF".
4.
Press the [A] button to return to the original
mode.
Adjusting
the
output
level
of
the speakers (SP GAIN)
Use the test tone function built into this unit to
adjust so that the volume that is output from all
speakers is the same.
• This item can be set only when the Dolby Pro
Logic
II
mode is set to "MUSIC" or "MATRIX".
• The factory default setting is
"OdB".
1.
Press the [A] button to set to the adjust
mode.
2.
Touch "t
IJ
1"
on the setting item display to
select "SP GAIN" under "SOUND".
3.
Touch
EDIT.
The mode changes to the SP GAIN
adjustment mode.
DXZ945MP
41
To Next Page
Loading...
