How to fix a Clarion Car Navigation system when the power does not turn on?
If your Clarion Car Navigation system doesn't turn on, and there's no sound, it might be due to a blown fuse. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Another cause could be incorrect wiring, in which case you should consult your installation center.
Why is the audio quality poor after connection with a Bluetooth enabled device to Clarion Car Receiver?
If the audio quality is poor after connecting a Bluetooth enabled device to your Clarion Car Receiver, the microphone may not be correctly positioned. Use optional external microphone and adjust the position of it. Also, the Bluetooth reception might be poor, so move the device closer to the car audio system or remove any obstacle between the device and the system.
Why does my Clarion NZ501E Car Receiver power not turn on?
If your Clarion Car Receiver doesn't power on, check the fuse. If it's blown, replace it with one of the same amperage. If the fuse blows again, consult your store of purchase. Also, incorrect wiring could be the cause, in which case you should consult your installation center.
Why is there no sound and no file display on my Clarion Car Navigation system?
If there's no sound and no file display on the file list of your Clarion Car Navigation system, it may be because no MP3/WMA file is stored in the USB device. Store these files properly in the USB device.
How to reset Clarion Car Navigation system when buttons don't work?
If nothing happens when you press the buttons and the display is not accurate on your Clarion Car Navigation system, the microprocessor may have malfunctioned. Press the reset button with a thin rod to turn off the power. Note that doing so will clear stored radio frequencies and titles.
Why won't my Clarion Car Navigation system load a disc?
If your Clarion Car Navigation system won't load a disc, make sure there isn't one already inside. Eject the disc before loading the new one. Also, check for any foreign matter in the disc slot and remove it, or consult a service station.
Why is there no power on my Clarion NZ501E?
If your Clarion Car Receiver isn't powering on and no sound is produced, it could be due to a blown fuse. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Another cause might be incorrect wiring, in which case you should consult your installation center.
What to do if Clarion Car Receiver buttons don't work and the display is inaccurate?
If the buttons on your Clarion Car Receiver aren't responding and the display is inaccurate, the microprocessor may have malfunctioned. To fix this, press the reset button with a thin rod. Note that pressing the reset button will turn off the power and clear stored radio frequencies and titles.
Why is the display dark on my Clarion Car Navigation system?
If the display on your Clarion Car Navigation system is dark, the brightness control may be too low. Adjust the brightness properly. The operating condition may not be good. Set to an appropriate temperature (25 or so) and check it again. The headlight of the vehicle may be lit.
What to do if the Clarion NZ501E Car Receiver disc cannot be loaded?
If your Clarion Car Receiver won't load a disc, it might be because a disc is already loaded. Eject the disc before loading the new one. Alternatively, there could be foreign matter already in the disc slot. Remove the foreign matter, or consult a service station.
General| Brand | Clarion |
|---|---|
| Model | NZ501E |
| Category | Car Receiver |
| Language | English |
To Next Page
